Sell Agm Separator

AGM glass mat separator is combination of AGM and glass mat with acid-proof glue as sticky material. It is an advanced material used as separator in flooded/vented storage battery.

It has such stable and reliable property as:

i)                    high acid-proof;

ii)                  high porosity and small pore size;

iii)                 high liquid absorptivity;

iv)               low electric resistance;

v)                capable of preventing short circuits;

vi)               unique saturation profile and lower stratification;

vii)             superior tensile strength;

viii)            faster upward wicking and faster downward wicking;

ix)               ability to absorb needed electrolyte which will supply it to whole of plate that will never allow plate to get dry and sulphurated;

x)                in case of low level of electrolyte in the battery, this advantage of AGM glass mat separator can help to improve the performance of the storage battery and lead to longer service life.

You will not find this type of absorbing electrolyte ability in any of other separators like PVC or PE envelope type separators. Hence it is superior to PVC and PE separators in many manners, especially in hot climate places.

It really does good to prolong the service life of flooded/vented lead acid battery and give out strong instant electric pulse for starting up automobiles/motorcycle. AGM glass mat separator is applied in automobile/motorcycle batteries, heavy-duty batteries and long life batteries.

It is produced with the newest formula in the world today and under top high technique. Characteristics of this separator are:

i)                    low electrical resistance: each piece lower than 1.5 mΩ*dm2;

ii)                  the largest pore size ≤18μm;

iii)                 porosity≥90%;

iv)               high anti-oxidation ability;

v)                stable chemical properties.

All these contribute to the high electricity reserve capacity, cold cranking performance, high discharging rate, and also prolong service life of batteries to 3 years. It can be used to produce high-performance batteries. It really helps the plates to show their overall performance in full capacity.  And with tight assembly technique, the plates can go all out of their full service life with the active material in paste being gradually used up at a higher rate, so that the service life of your battery can be longer.

AGM glass mat separator is like AGM material for VRLA battery in its property similar to a sponge. So that while making battery with this kind of AGM glass mat separator, tight sandwich assembly like VRLA batteries is also required. Separators of this kind should be pressed together with plates by 10% of total thickness of separator while making group (element) for every cell.

No sliding of AGM glass mat separator in liquid between plates is allowed. Plates must be smooth and tidy with no burr, no sharp edges that may cut or damage the separator.

When inserting AGM glass mat separator between plates, no damage should be done to AGM glass mat separator, causing them to be worn out, torn open or broken to small pieces.

You can make battery of higher quality for sure with this type of AGM glass mat separator.